For USB 2.0, use of a Y-cable connected to two USB 2.0 ports is required to properly power the HD-CONV-USB-300. Off indicates that the source is not using HDCP. Blue indicates that the source is using HDCP 2.2. Red indicates that the source is using HDCP 1.x. Green indicates that the software on the connected PC is actively receiving video from the unit via USB. Red indicates that there is no HDMI source. Green indicates that there is an HDMI source. USB 3.0 Type‑B male to Type‑A male cable included ![]() HDMI or analog audio input (selectable in configuration software) HDMI: 4K UHD 60 fps 4:4:4 with support for 12‑bit HDR HDMI 2.0 (DVI 1.0 compatible) loop out port with support for HDCP 2.2/1.xĤK UHD 60 fps 4:4:4 with support for 12‑bit HDR Specifications are subject to change without notice. Crestron is not responsible for errors in typography or photography. Crestron disclaims any proprietary interest in the marks and names of others. Other trademarks, registered trademarks, and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. in the United States and/or other countries. UL is either a trademark or registered trademark of Underwriters Laboratories, Inc. ![]() HDMI and the HDMI logo are either trademarks or registered trademarks of HDMI Licensing LLC in the United States and/or other countries. For specific information, please visit Crestron and the Crestron logo are either trademarks or registered trademarks of Crestron Electronics, Inc. The specific patents that cover Crestron products are listed online at .Ĭertain Crestron products contain open source software. This product is covered under the Crestron standard limited warranty. A list of sales representatives is available online at or by calling 855‑263‑8754. To find a dealer or distributor, please contact the Crestron sales representative for your area. This product may be purchased from select authorized Crestron dealers and distributors. HDCP content can be displayed on the HDMI output only. HDCP encrypted sources cannot be converted to USB.Note that a Y‑cable (not included) is required when connected via USB 2.0 to deliver the necessary power. Compatible with USB 2.0 capture, but minimal MJPEG compression is applied.Simply connect the room’s microphone and HDMI camera to the HD-CONV-USB-300 and connect via USB to the user’s laptop to start the meeting from a soft codec while using the room’s superior camera and microphone, You can also install this device in an existing video conferencing room to add BYOM (Bring Your Own Meeting) capability. ![]() The HDMI output can connect the camera signal back to the existing UC codec while the captured USB stream feeds into the new UC codec. For example, if you need to install a secondary UC codec to an existing installation, you can share the microphone and HDMI camera devices by feeding these signals into the HD-CONV-USB-300. The HD-CONV-USB-300 can be used for stand‑alone video conversion or as part of an integrated UC (unified communications) solution. By using the HDMI output and analog audio input, you can leverage existing video conferencing equipment in the room. Video timing stabilization helps to ensure a reliable and stable USB capture stream. Input resolutions larger than Full HD and up to 4K UHD are automatically scaled to 1080p for USB capture. USB capture is accomplished using the USB Video Class (UVC) and USB Audio Class (UAC) standards, which are compatible with the most common video capture or streaming software applications. The device captures uncompressed 1080p60 video with stereo digital or analog audio. The Crestron HD-CONV-USB-300 converts an HDMI® signal to USB 3.0.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |